<noframes id="ptxlv"><form id="ptxlv"></form>

<address id="ptxlv"><nobr id="ptxlv"><meter id="ptxlv"></meter></nobr></address>
<em id="ptxlv"></em>
<noframes id="ptxlv"><form id="ptxlv"><nobr id="ptxlv"></nobr></form>

    Fluent中湍流強度(Turbulence Intensity)的基本定義和理解

    2022-12-29  by:CAE仿真在線  來源:互聯網

    關于的基本公式是這樣的:


    Fluent中湍流強度(Turbulence Intensity)的基本定義和理解fluent圖片1

    稍微解釋一下就是

    1、他是一種比值,衡量的是湍流的程度,所以fluent后面給他帶了個單位是%,百分比的單位

    2、他是用來衡量湍流的程度的,所以并不是兩個速度的比值,而是速度波動程度相對于平均速度的比值。而速度波動描述的就是湍流的特征。

    這個值會因為采用模型不同而有不同,一般10%一下算是較小的,而20%算是較大的,但是也有300%及其以上的,比如流速變化劇烈的局部區域,這也不奇怪。

    下面是具體來源和官方的解釋:


    https://ansyshelp.ansys.com/account/Secured?returnurl=/Views/Secured/corp/v181/en/flu_ug/x1-4300008.63.2.html

    文檔位置:help/flu_ug/x1-4300008.63.2.html


    Fluent中湍流強度(Turbulence Intensity)的基本定義和理解fluent仿真分析圖片2



    7.4.2.1.3. Turbulence Intensity
    The turbulence intensity, , is defined as the ratio of the root-mean-square of the velocity fluctuations, , to the mean flow velocity, .

    A turbulence intensity of 1% or less is generally considered low and turbulence intensities greater than 10% are considered high. Ideally, you will have a good estimate of the turbulence intensity at the inlet boundary from external, measured data. For example, if you are simulating a wind-tunnel experiment, the turbulence intensity in the free stream is usually available from the tunnel characteristics. In modern low-turbulence wind tunnels, the free-stream turbulence intensity may be as low as 0.05%.

    For internal flows, the turbulence intensity at the inlets is totally dependent on the upstream history of the flow. If the flow upstream is under-developed and undisturbed, you can use a low turbulence intensity. If the flow is fully developed, the turbulence intensity may be as high as a few percent. The turbulence intensity at the core of a fully-developed duct flow can be estimated from the following formula derived from an empirical correlation for pipe flows:

    Fluent中湍流強度(Turbulence Intensity)的基本定義和理解fluent圖片1(7–71)
    At a Reynolds number of 50,000, for example, the turbulence intensity will be 4%, according to this formula.

    The default value for turbulence intensity is 5% (medium intensity).



    開放分享:優質有限元技術文章,助你自學成才

    相關標簽搜索:Fluent中湍流強度(Turbulence Intensity)的基本定義和理解 Fluent培訓 Fluent流體培訓 Fluent軟件培訓 fluent技術教程 fluent在線視頻教程 fluent資料下載 fluent分析理論 fluent化學反應 fluent軟件下載 UDF編程代做 Fluent、CFX流體分析 HFSS電磁分析 

    編輯
    在線報名:
    • 客服在線請直接聯系我們的客服,您也可以通過下面的方式進行在線報名,我們會及時給您回復電話,謝謝!
    驗證碼

    全國服務熱線

    1358-032-9919

    廣州公司:
    廣州市環市中路306號金鷹大廈3800
    電話:13580329919
              135-8032-9919
    培訓QQ咨詢:點擊咨詢 點擊咨詢
    項目QQ咨詢:點擊咨詢
    email:kf@1cae.com